Publicité
Operating instructions - Connecting water / Electrical power
Connecting Main Water Supply
1. Connect high pressure hose to the pump output outlet (1).
of the pressure washer.
2. Ensure twist coupler (2) is fi rmly tightened.
3. Use quick twist connect 3/4" MGT water inlet hose fitting coupler
to attach garden hose to water inlet on pump (3)
4. Ensure that the faucet is turned on and water is running into the
pressure washer
5. With power OFF – Depress the spray gun trigger to ensure the
water flows through hose and wand.
DANGER
• The water supply outlet must be able to deliver proper amount of water flow to the pressure washer
(minimum 2,2 gallons per minute )
• Do not supply water to the pressure washer that exceeds a temperature of 40°C /98°F or below 5°C/41°F.
• The pressure of the water supply must not exceed 8 bar/116 psi and no less than 20 psi.
Connecting to Main Power Supply
1. Ensure the motor switch is in the «OFF» «0» position.
2. Ensure electrical supply is identical to the specifi cations
listed on the pressure washer data label.
3. GROUNDING INSTRUCTIONS: This product must be
grounded to reduce the risk of electric shock.
This product is equipped with a 3 pronged electrical cord.
The pressure washer must be plugged into the proper
grounded power outlet that is in accordance with all local
codes and ordinances.
CAUTION
If using an extension cord - The cord should not exceed 10
meters (35 feet) in length. Connection should be waterproof.
WARNING
The pressure washer should be plugged into a power
outlet that is properly grounded and supported by a circuit
breaker or fuse.
The voltage on the power outlet should be constant and
not vary by more than ±5%.
DANGER
DANGER: Improper connection of the equipment-groun-
ding conductor can result in a risk of electrocution.
Verify with a qualifi ed electrician or service personnel that
power outlet is properly grounded. Do not modify the plug
- if it does not fi t the outlet, have a proper power outlet
installed.
12
Publicité
