Publicité
Operating instructions - Safety features and devices
Thermal protector stops the operation of the pressure washer in the event
the electrical motor is overheating.
IF THE MACHINE IS STOPPED BY THERMAL PROTECTOR:
• Main power switch should be put to the OFF «0» position. Then remove the plug from the power outlet.
• Press the trigger/lever on the spray gun to release any remaining water pressure.
• Wait 10 to 15 minutes until the pressure washer cools down.
VERIFY CONNECTIONS TO THE MAIN ELECTRICAL SUPPLY,
Ensure the power cord is not damaged. Check extension cord (if being used) for faulty receptacle plug/avoid using extension
cords that exceed 35 feet. It is recommended that the extension cord have a plug and socket that are waterproof. Replace the
electric plug into the power outlet and repeat the start-up procedure.
IMPORTANT
If this safety device continues to cut power repeatedly, do not use the pressure washer until it has been checked by an
Authorized Service Technician.
Total Stop stops operation of the pressure washer each time the spray gun control
trigger / lever on the pressure washer is released.
WARNING
It is important to remember that the pressure washer is still operational when in Total Stop mode.
IMPORTANT
Before leaving a machine unattended even for a short time, always set the main power switch to the OFF "0" position ,
remove the electrical plug from the power outlet, press the trigger /lever on the spray gun to eliminate any remaining pres-
sure and open the trigger safety lock.
Easy Start assists start up of the pressure washer by introducing water at a lower rate of pres-
sure for the fi rst moments of operation when the spray gun lever is depressed and gradually
builds to full output.
13
Publicité
