Publicité
Les langues disponibles
Les langues disponibles
Using the answer machine (handset)
New message is indicated in the display in standby mode. Playback always starts with new messages.
1. Press Menu. Scroll to Answer Machine. Press Select.
2. Scroll to Playback. Press Ok.
3. During playback the following commands are available or press Menu and scroll to the desired function.
4. End by pressing
L
Command
Function
2 (X).................Delete during playback
4 (
) . ............Previous message
8 8
5 (■) .................Stop
6 (
) . ............Skip to next message
9 9
......................Speaker On/Off
/
. ...............Volume control
}
{
Delete all old messages
1. Press Menu. Scroll to Answer Machine. Press Select.
2. Scroll to Delete All. Press Ok.
3. Confirm by pressing Ok.
Answer Machine Settings
1. Press Menu. Scroll to Answer Machine. Press Select.
2. Scroll to TAM Settings. Press Select.
3. Scroll to desired function. Press Select.
4. Scroll to desired setting. Press Select.
Answer Mode
Choose between Answer & Record and Answer Only (caller cannot leave a message).
TAM Language
Select language for pre-recorded out-going message. To activate this function select Default under OGM
Settings.
OGM Settings
Record/listen to outgoing msg.
Answer Delay
Select after how many rings (2-9, Time Saver*) the call will be answered.
Recording Time
Select maximum recording time for each msg.
Base Screening
See separate description of this function in the base unit.
Remote Access
Select remote access on/off.
Chg Remote PIN Change remote access code (0000).
*The Time Saver function answers calls after six ring signals, until the first new message has been registered - then the answer
machine switches to answering after approximately two signals. This is useful when using remote access; if you call up the
answer machine and there is no reply after four rings that means there are no messages recorded and you can hang up before
you are charged for the call.
Personal message (Memo)
1. Press Menu. Scroll to Answer Machine. Press Select.
2. Scroll to Memo. Press Select.
3. After the long beep you can record your message (speaking approx. 20 cm from the keypad).
4. Press Ok. The message will be played back to you.
5. Memos are played back in the same way as ordinary incoming messages.
.
English
Publicité
