If you have only "00000", on the screen, please refer to
the paragraph dedicated to the generic code.
Thereafter, the program steps are changed using the
key3 (to move to the right the flashing digit) and the
key4 (to change the value of flashing the digit).
Without actuation of the keys for 30 seconds, the
instrument returns to its initial state. Press key 2 for 5
seconds in order to resume programming and then, by
means of pulsing, reach the interrupted stage.
(G
CHRONOMETRIC VERSION
ENERIC CODE
Press key 2, and keep it pressed for at least 5 seconds.
The display shows "P003". Set the current time (hour and
minutes).
Again press key 2, the display shows "P020". Then set the
frequency
in
days
(according to consumption and cycle of the softener,
see table n°1.5).
Press key 2, the screen shows "P050". Adjust the total
duration of the regeneration in minutes (see table n°1.4).
Press key 2, the screen shows "P080". Then adjust the time
when you want to start the regeneration of your
softener.
End the programming by pressing key 2, the screen
again shows the current time and the time of the next
regeneration.
(C
VOLUMETRIC VERSION
ODES
Press key 2 and keep it pressed for at least 5 seconds.
The display shows "P003". Set the day of the week
(1=Monday, 2=Tuesday, 3=Wednesday, etc.) and the
current hour and minutes.
Again press key 2, the display shows "P080". Set the time
when you want to start the regeneration of the softener.
Press key 2, the screen shows "P050". Set the total
duration of the regeneration in minutes (see table n°1.4).
Press key 2, the screen shows "P040". Adjust the cycle of
the softener, that is to say, the volume of softened
ind.04 du 26/11/2009
10110) Z:
between
two
regenerations
12120 & 22120) SE
B
AND
IO
GB-
water, produced between 2 regenerations (table
n°1.5)."L" (litre) can be replaced with "H" (hectolitre) if
necessary with keys 3 and 4.
Press key 2, the screen shows "P071". Repeat the
operation to scroll on the screen, in turn, "P072", "P073",
"P074", "P075", "P076" and "P077". Do not modify the
values "00300" which are the averages per day,
programmed in the factory. The microprocessor of your
BEWAMAT, when placed under voltage, automatically
calculates daily the average of consumption. The
values of "P071" to "P077" are therefore constantly
updated.
End the programming by pressing key 2, the screen
shows the actual hours and minutes or the initial cycle
"01000".
G
C
ENERIC
ODE
If the display indicates "00000" when you plug your
softener, a generic code has to be registered using the
keys 2 and 5.
The 3 allowed codes are:
10110 for a softener type Z (without watermeter)
-
12120 for a softener type SE (with watermeter)
-
22120 for softener type BIO (with watermeter
-
:
and chlorination cell).
The validation of the code is achieved using the key 5.
After entering the generic code, the program steps can
be registered as explained above. It is possible that
some additional steps appear during programming.
They are intended for qualified technicians and it is
recommended not to change them:
P100 for the commissioning date
-
P001 and P002 for the current date
-
P031, P032 and P033 for the alarms.
-
8
Instruction BEWAMAT
:
P0010923