Dräger X-plore 5500 Notice D'utilisation page 13

4.6 After use
1. Remove the full face mask: Insert your index fingers underneath the flaps of
the neck straps (see fold-out page, Figure F). Push the adjusting clamps
forward with your thumbs and pull the full face mask away from your face
and over your head at the same time. Do not pull on the connector or filter
when doing so.
2. Remove and dispose of both respiratory filters.
4.7 Maintenance work and maintenance intervals
For information about maintenance work and maintenance intervals, see the
technical manual, part number: 9300783 at www.draeger.com/ifu
5 Transport
Transport the full face mask in a carrying box or mask bag.
6 Storage
Dräger X-plore 5500
● Loosen the harness as far as possible.
● Wipe the visor with an antistatic cloth.
● Pack the full face mask in its bag or mask carrying box.
● Store it in a dry, dust-free place where it cannot become deformed.
Storage temperature: -15 °C to +25 °C.
● Protect from direct sunlight and thermal radiation.
● Observe ISO 2230 "Rubber Products - Guidelines for Storage" and national
regulations concerning the storage, maintenance and cleaning of rubber
products.
Dräger rubber products are treated with an agent to protect against premature
ageing which in some cases is visible as a grey-white coating. This coating can
be washed off with a brush and soapy water.
7 Disposal
Dispose of the product in accordance with the applicable rules and regulations.
Instructions for use |
Dräger X-plore 5500
| en
Transport
13