Kärcher Pro HD 700 X Mode D'emploi page 11

The high-pressure jet must not be directed at
persons, animals, live electrical equipment or
at the device itself. Protect the device from
frost.
Safety devices
CAUTION
Missing or modified safety devices
Safety devices are provided for your own protection.
Never modify or bypass safety devices.
The safety devices are set and sealed by the manufac-
turer. Adjustments are performed only by customer ser-
vice.
Pressure switch
When the trigger on the high-pressure gun is released,
the pressure switch switches off the high-pressure
pump and the high-pressure jet stops.
The pump switches on again when the trigger is pulled.
Device description
Overview of the unit
See graphics page
Hubcap
1
Nozzle holder
2
Skid
3
Type plate
4
Nozzle storage for triple nozzle
5
Transport retainer for surface cleaner
6
Push handle lock
7
Push handle, bottom (pushed in)
8
Push handle, top (pulled out)
9
High-pressure nozzle
10
High-pressure nozzle marking
11
EASY!Lock spray lance
12
EASY!Force high-pressure gun
13
Safety latch
14
Trigger
15
Safety lever
16
EASY!Lock high-pressure hose
17
Hose storage compartment
18
Cable clips
19
Spray lance holder without a clamp
20
Rubber band (not in devices with a hose reel)
21
Nozzle storage compartment for rotary nozzle (rota-
22
ry nozzle only included in the scope of delivery of
the "Plus" variant)
Spray lance holder with a clamp for transport
23
Power switch
24
Handle
25
EASY!Lock high-pressure connection
26
Handle
27
Water connection
28
Detergent suction hose with filter and detergent
29
dosing unit
sieve
30
Hose spout
31
Union nut
32
Crank
33
Hose reel
34
● Control elements for the cleaning process are yel-
low.
● Control elements for maintenance and servicing are
light grey.
Fastening the hubcaps
 Fasten the hubcaps.
Installing accessories
Note
The EASY!Lock system connects components quickly
and safely via a single turn of the quick-release thread.
1. Fit the high-pressure nozzle onto the spray lance
with the marking facing upwards.
2. Tighten the high-pressure nozzle hand-tight
(EASY!Lock).
3. Connect the spray lance to the high-pressure gun
and hand-tighten (EASY!Lock).
1.
4. Release the push handle lock.
5. Pull the push handle out to the end position.
For devices without a hose reel:
6. Connect the high-pressure hose to the high-pres-
sure gun and high-pressure connection of the de-
vice and tighten hand-tight (EASY!Lock).
For devices with a hose reel:
7. Lay the high-pressure hose on the ground in a
straight line.
8. Insert the crank into the hose reel shaft and latch in-
to position.
9. Turn the crank clockwise and wind the high-pres-
sure hose onto the hose reel in evenly distributed
layers.
10. Connect the high-pressure hose to the high-pres-
sure gun and hand-tighten (EASY!Lock).
English
Colour coding
Installation
2.
11