HSM shredstar X12pro Notice D'utilisation page 12

english
Shredding CDs / DVDs
WARNING
Danger of injury by splinters!
Depending on the type of mate-
rial, splinters can fly out of the
cutting unit while shredding CDs
and injure your eyes .
• For this reason, wear protective goggles.
• Feed in just one CD/DVD in the middle of
the feed opening .
• Empty the CD container at the latest
after shredding 5 CDs . The separate CD
container is in the shredded material con-
tainer .
Shredding credit cards and store
cards
• Insert credit card in centre of the feed
opening . Dispose of the shredded material
and the waste paper separately .
Switching off the shredder
• Press the operation button .
 The "Ready for operation" indicator
goes out .
• Set mains switch at rear of paper shredder
to "0" .
12
6 LED displays, troubleshooting
Power
Appliance is ready for use
Overheat
The motor has overheated .
• Let the shredder cool down for approx .
30 mins . before using it again .
Overload
Machine is overloaded . You have fed in
too much paper .
 The cutting unit runs in reverse for a few
seconds and pushes the paper back out
again .
• If necessary, press the reverse button "R"
to remove the stack of paper .
• Take half the stack of paper .
• Feed the paper in portions .
Bin full
 The display in the control unit lights up .
The cutting unit is switched off.
NOTICE
Empty the cut material container, immedi-
ately because if it is too full, malfunctions
can occur in the cutting system .
• Empty cut material container .
Note
If you press the reverse button briefly before
removing the container, part of the material
is pulled back into the cutting apparatus and
does not fall inside the document shredder .
Note
The fill level sensor is on the underside of
the cutting head . Clean the sensor if the dis-
play remains on even after the container for
shredded material has been emptied .
HSM shredstar
08/2022