Important Safety Instructions; Electrical Safety; General Safety - Pentair INTELLIBOOST MIB0715B Manuel D'utilisation

IMPORTANT SAFETY
INSTRUCTIONS
SAVE THESE INSTRUCTIONS -
This manual contains important
instructions that should be followed
during installation, operation, and
maintenance of the product. Save this
manual for future reference.
This is the safety alert symbol. When
you see this symbol on your pump or in
this manual, look for one of the following
signal words and be alert to the potential
for personal injury!
indicates a hazard which,
if not avoided, will result in death or
serious injury.
indicates a hazard which,
if not avoided, could result in death or
serious injury.
indicates a hazard which,
if not avoided, could result in minor or
moderate injury.
NOTICE addresses practices not related
to personal injury.
Carefully read and follow all safety
instructions in this manual and on pump.
Keep safety labels in good condition.
Replace missing or damaged safety
labels.
California Proposition 65 Warning
This product and related
accessories contain chemicals known to
the State of California to cause cancer,
birth defects or other reproductive harm.

ELECTRICAL SAFETY

Hazardous voltage.
Capacitor voltage may be hazardous. To
discharge the Variable Frequency Drive
(VFD) capacitor, disconnect the pump
from the power supply and wait at least 5
minutes.
IMPORTANT: DO NOT assume that the
capacitor is discharged. Disconnect the
power, wait the 5 minutes, and only then
begin work on the pump or VFD. If in
doubt, consult a qualified electrician.
Also, this pump is designed to operate
ONLY on a 230V, 1-Phase, AC power
supply. The VFD converts 230V 1-Phase
AC to correct power for the pump motor.
DO NOT attempt to operate the motor, or
connect the motor to any power source,
unless the VFD is installed and operating
correctly. DO NOT put a plug on the power
cable and try to operate the pump as a
plug-in unit.
Electrical shock hazard. Do
not touch terminals. Terminals may be
energized in the open position even when
screen is blank.

GENERAL SAFETY

Risk of burns. Do not touch
an operating motor. Motors are designed
to operate at high temperatures. To avoid
burns when servicing pump, shut it down
and allow it to cool for 20 minutes before
handling it.
Do not allow pump or any system
component to freeze. To do so will void
the warranty.
Pump clean water only with this pump.
Periodically inspect pump and system
components.
Wear safety glasses at all times when
working on pumps.
Keep work area clean, uncluttered
and properly lighted; store properly all
unused tools and equipment.
Keep visitors at a safe distance from the
work areas.
2