Cip Approval Mark; Health And Safety Of The User; Noise Information - Hilti DX462 CM Mode D'emploi

13. CIP approval mark

The following applies to C.I.P. member states outside
the EU and EFTA judicial area:
The Hilti DX 462 HM/CM has been system and type
tested. As a result, the tool bears the square approval
mark showing approval number S 812. Hilti thus gua-
en
rantees compliance with the approved type.

14. Health and safety of the user

Noise information

Powder-actuated tool
Type:
Modell:
Caliber:
Power setting:
Application:
Declared measured values of noise characteristics according to 2006/42/EC
Machinery Directive in conjunction with E DIN EN 15895
Noise (power) level:
Emission noise-pressure level in the work station:
Peak sound pressure emission level:
Operation and set-up conditions:
Set-up and operation of the pin driver in accordance with E DIN EN 15895-1 in the semi-anechoic test room of
Mü l ler-BBM GmbH. The ambient conditions in the test room conform to DIN EN ISO 3745.
Testing procedure:
Enveloping surface method in anechoic room on reflective surface area in accordance with E DIN EN 15895, DIN
EN ISO 3745 and DIN EN ISO 11201.
NOTE: The noise emissions measured and the associated measurement uncertainty represent the upper limit for
the noise values to be expected during the measurements.
Variations in operating conditions may cause deviations from these emission values.
1 ± 2 dB (A)
2 ± 2 dB (A)
3 ± 2 dB (C)
Vibration
The declared total vibration value according to 2006/42/EC does not exceed 2.5 m/s
Further information regarding the health and safety of the user can be found at the Hilti web site: www.hilti.com/hse
26
Printed: 12.08.2013 | Doc-Nr: PUB / 5069843 / 000 / 02
Unacceptable defects or deficiencies, etc. determined
during use of the tool must be reported to the person
responsible at the approval authority (PTB, Braun-
schweig)) and to the Office of the Permanent Interna-
tional Commission (C.I.P.) (Permanent Internationial
Commission, Avenue de la Renaissance 30, B-1000
Brussels, Belgium).
DX 462 HM/CM
Serial production
6.8/11 green
4
Marking steel blocks with embossed characters
(400×400×50 mm)
DX 462 HM
L 1 110 dB(A)
WA, 1s
L 2 108 dB(A)
pA, 1s
L 3 135 dB(C)
pC, peak
DX462 CM
108 dB(A)
107 dB(A)
134 dB(C)
2 .