Manufacturer's Warranty - Tools; Ec Declaration Of Conformity (Original); Confirmation Of Cip Testing; Health And Safety Of The Operator - Hilti DX 351-CT Mode D'emploi

11 Manufacturer's warranty - tools

Please contact your local Hilti representative if you have
questions about the warranty conditions.

12 EC declaration of conformity (original)

Designation:
Type:
Generation:
Year of design:
We declare, on our sole responsibility, that this product
complies with the following directives and standards:
2006/42/EC, 2011/65/EU.

13 Confirmation of CIP testing

The Hilti DX 351 CT has been system and type tested.
As a result, the tool bears the rectangular PTB approval
mark showing approval number S 817. Hilti thus guaran-
tees compliance with the approved type. Unacceptable

14 Health and safety of the operator

14.1 Noise information

Powder-actuated fastening tool
Type
Model
Caliber
Power regulation
Application
Printed: 17.04.2014 | Doc-Nr: PUB / 5069830 / 000 / 03
Powder-actuated fasten-
ing tool
DX 351‑CT
01
2008
Hilti Corporation, Feldkircherstrasse 100,
FL‑9494 Schaan
Norbert Wohlwend
Head of Quality & Processes Manage-
ment
BU Direct Fastening
04/2013
Technical documentation filed at:
Hilti Entwicklungsgesellschaft mbH
Zulassung Elektrowerkzeuge
Hiltistrasse 6
86916 Kaufering
Deutschland
defects or deficiencies, etc. determined during use of the
tool must be reported to the person responsible at the ap-
proval authority (PTB) and to the Office of the Permanent
International Commission (C.I.P.).
DX 351‑CT
Series
6.8/11 red
3
Fastening 0.75 mm steel sheet to concrete (B35) using
X‑U 27P8
en
Tassilo Deinzer
Head of BU Direct Fastening
BU Direct Fastening
04/2013
13