Operation; Reloading The Tool - Hilti DX462 CM Mode D'emploi

7. Operation

en
20
Printed: 12.08.2013 | Doc-Nr: PUB / 5069843 / 000 / 02
CAUTION
■ The base material may splinter
or fragments of the cartridge strip
may fly off.
■ Flying fragments may injure parts
of the body or the eyes.
■ Wear safety goggles and a hard
hat (users and bystanders).
CAUTION
■ The marking is achieved by a car-
tridge being fired.
■ Excessive noise may damage the
hearing.
■ Wear ear protection (users and
bystanders).
WARNING
■ The tool could be made ready to
fire if pressed against a part of
the body (e.g. hand)..
■ When in the "ready to fire" state,
a marking head could be driven
into a part of the body.
■ Never press the marking head of
the tool against parts of the body.
WARNING
■ Under certain circumstances, the
tool could be made ready to fire
by pulling back the marking head.
■ When in the "ready to fire" state,
a marking head could be driven
into a part of the body.
■ Never pull back the marking head
by hand.
aa
7.1 Loading the characters
The marking head can receive 7 characters 8 mm width
or 10 characters 5.6 mm width
1. Insert the characters according to the mark desired.
Locking lever in the unblocked position.
2. Always insert the marking characters in the middle
of the marking head. An equal number of space char-
acters should be inserted on each side of the string
of characters.
3. If necessary, compensate an uneven edge distance
by using the <–> marking character. This helps ensu-
re an even impact.
4. After inserting the desired marking characters, they
must be secured by turning the locking lever.
5. The tool and head are now in the ready to operate
position.
CAUTION :
● Use only original space characters as blank space. In
emergency, a normal character can be ground off and
used.
● Do not insert marking characters upside-down. This
results in shorter life length of the impact extractor and
reduces the marking quality
aa
7.2 Inserting the cartridge strip
Load the cartridge strip (narrow end first) by inserting
it into the bottom of the tool grip until flush. If the strip
has been partly used, pull it through until an unused car-
tridge is in the chamber. (The last visible number on the
back of the cartridge strip indicates which cartridge is
next to be fired.)
aa
7.3 Adjusting the driving power
Select a cartridge power level and power setting to suit
the application. If you cannot estimate this on the basis
of previous experience, always begin with the lowest
power.
1. Press the release button.
2. Turn the power regulation wheel to 1.
3. Fire the tool.
4. If the mark is not clear enough (i.e. not deep enough),
increase the power setting by turning the power regu-
lation wheel. If necessary, use a more powerful car-
tridge.
aa
7.4 Marking with the tool
1. Press the tool firmly against the work surface at right
angle.
2. Fire the tool by pulling the trigger
WARNING
● Never press the marking head with the palm of your
hand. This is an accident hazard.
● Never exceed the maximum fastener driving rate.

7.5 Reloading the tool

Remove the used cartridge strip by pulling it upwards
out of the tool. Load a new cartridge strip.