EUROM OUTDOOR HEATPANEL RC Mode D'emploi page 17

Outdoor Heatpanel RC:
 The OUTDOOR HEAT PANEL RC has two rails (A) at the back containing 2 x 2 slider
assembly bolts (B). Slide them onto the position where you want to affix the mounting
bracket. The brackets should be a minimum of 60 cm apart and the space between
them should be equal between both sides.
 Position both mounting brackets (D) over the 2 x 2 bolts (B), put a ring over each bolt
and screw them tightly into place with the 4 nuts (ring + nut = C).
 See the image for the entire mounting process.
Outdoor Heatpanel & Outdoor Heatpanel RC:
 Screw both wall supports loosely between the hanging brackets with the 2 screws (X) and
nuts (Z) supplied.
 Attach the wall supports using both small screws (Y). (RC: and nuts (Z) in the middle
position.
 Select the location for the Outdoor Heat pane (RC)l, taking all of the instructions into
account. Mark the location for the 4 drilled holes on the wall/ceiling. Ensure that the Heat
panel (RC) hangs horizontally!
 Unscrew both wall supports and secure them firmly to the marked location on the
wall/ceiling. Use wedge bolts for brick or concrete and ask for advice about attachment
materials for any other surfaces.
 Now secure the Heat panel (RC) firmly to the wall supports with the hanging brackets using
both screws and bolts (X & Z).
 The heating direction of the OUTDOOR HEAT PANEL (RC) can be adjusted using 3
settings. Only change the setting when the panel has cooled down completely and is
disconnected from the energy supply! Secure the heating direction at the designed
17