Publicité
Les langues disponibles
Les langues disponibles
15
Permanent installation:
The OUTDOOR HEATPANEL (RC) is designed to be installed at a permanent location and be
connected directly to the mains. The installation must be equipped with an (RC: extra) on/off
switch. For safety reasons, this installation must be carried out by a professional electrician.
Temporary facility:
As a temporary facility, the OUTDOOR HEATPANEL (RC) can be directly connected to a socket
via its electric cable and plug. The OUTDOOR HEATPANEL is then switched on and off by
inserting or removing the plug from the socket (RC-model has a switch). Ensure that the electric
cable does not hang off sharp edges, is not twisted around sharp corners, cannot be dragged
along and does not come into contact with any hot surfaces.
Important: electrical cable and plug form one, single unit. If the electric cable or plug becomes
damaged, they must be replaced in their entirety by an electrician. Only allow original parts to
be used!
Location
The OUTDOOR HEATPANEL (RC) must be installed with its lowest point at least 180 cm from
the ground for both wall and ceiling installation.
When installing Outdoors, under a roof covering, the most effective installation height is
between 220/240 and 270 cm. Never hang the OUTDOOR HEATPANEL (RC) higher than 320
cm above the ground. Minimum distance to ceiling or sidewall: 20 cm., see also picture (the
model may differ!). Keep on at least one meter around the Heatpanel free of obstacles.
Ceiling installation:
Wall installation:
Carefully select the right position for your OUTDOOR HEATPANEL (RC), taking the regulations
into account. The device must be installed on a non-flammable surface. The surface must also
be free from vibrations, completely vertical (when mounting on a wall) and sufficiently sturdy to
bear the device correctly for the long-term.
Publicité
