Cub Cadet Power Lok CCT410 Manuel D'utilisation page 13

Instructions for charging the Power Cell are packed with the charger.
WARNING:
the charger.
INSTALLING THE DRIVE UNIT ON AN
ATTACHMENT
NOTE:
The Power Lok™ Drive Unit
must be installed on the Trimmer
Attachment. If the unit you purchased
does NOT include the drive unit, one
must be purchased separately. Refer
to the Accessories section.
WARNING:
Cell from the drive unit before installing
it on the attachment.
1. Pull the locking lever (1) outward
from the locking collar (2). Align the
groove (3) in the locking collar with
the matching key (4) on the end of
the attachment shaft (5) (Fig. 1).
2. Insert the attachment shaft into the
locking collar until the installation
mark (6) meets the locking collar
(Fig. 1).
NOTE: Make sure the attachment shaft
is fully inserted into the locking collar. If
it is not fully inserted, the electrical
connection will not be made and the
attachment will not function properly.
3. When the attachment shaft is fully
inserted into the locking collar, push
the locking lever back toward the
locking collar to lock the assembly
together (Fig 2).
ASSEMBLY AND OPERATING
Read all safety warnings and charging instructions included with
Remove the Power
3
4
6
13
2
5
Fig. 1
Fig. 2
1