Publicité
Les langues disponibles
Les langues disponibles
PREPARE THE CABINET (
6 . Measure the distance between both bottom bracket
edges (F) (FIG . 10) . The table below shows the approriate
distance needed .
N
arrow edge
F
From 27-7/8" to < 28-1/16"
If the measured distance needs to be shortened, screw two
no . 8-32 x 1/4" machine screws, in each bottom embossed
cabinet brackets hole; this will slightly bend the bottom part
of the brackets (FIG . 11) . Screw both brackets until the
appropriate distance is obtained .
7 . Optional
There are 7 different sizes of fillers (sold separately)
designed to fit up to 15-in . depth cabinets (order
HADTBN30) . Choose the filler that fits better to cover the
back bottom edge of the cabinet . Use 4 no . 6 x 1/2" truss
head wood screws (included in the optional kit) to mount
it (FIG . 12) .
CAUTION
Never use an electric screwdriver or drill to screw the
filler to the bottom edge of cabinet; use a standard
screwdriver .
H
orizontal exHaust installation only
This powerpack insert is factory shipped to exhaust vertically;
however, it is possible to make it exhaust horizontally (3¼" x 10"
ducting only) .
8 . Cut the hole for the horizontal exhaust through the back
wall of the cabinet using the dimensions shown . (FIG . 13) .
'
)
cont
d
w
ide edge
F
From 28-1/16" to 28-5/16"
F
HD1376
Screws in bottom
embossed holes
F
HD1377
HD1373
CABINET BACK WALL
5¼"
5¼"
3/4"
CABINET BOTTOM
HH0318A
FIG. 10
FIG. 11
FIG. 12
3½"
9
FIG. 13
Publicité
