Publicité
Les langues disponibles
Les langues disponibles
INSTALL THE UNIT
1 . Run house power cable between service panel and unit
location . Stub out a 2-foot length of power cable inside
the cabinet . Insert the power cable in the unit through the
7/8" diameter strain relief previously installed .
NOTE: Not necessary if the optional HCK44 cord
2 . Insert the unit in the cabinet, until you feel a 'click' from
both sides of the unit, confirming that the Ease of Install
hooks rest on the top of the cabinet bottom sides , or
cabinet brackets or (FIG . 23) . Move the unit from
left to right, from rear to front and up to ensure the Ease
of Install hooks are retaining the unit inside the cabinet .
NOTE: The unit will be protruding below the cabinetry until
NOTE: If, for any reason, the unit has to be removed
from the cabinet, it is possible to disengage the
Ease of Install hooks . To do so, while holding and
pushing on one side of the unit, lift simultaneously
Ease of Install hooks levers (1 and 2, grey parts
in FIG . 24) in the other side of the unit until the
hooks are retracted .
12
connection kit is used .
tightened .
HD1374
HD1375
FIG. 23
2
1
FIG. 24
Publicité
