Publicité
Les langues disponibles
Les langues disponibles
PREPARE THE CABINET
WARNING
!
The cabinet must be secured to wall studs or other
wooden framework behind the drywall to support
the weight of this unit . Failure to do so may cause
personal injury or damage to countertop or cooktop .
NOTES: A . The unit has to be installed inside the cabinet .
B . The unit should be mounted centered laterally
over the cooktop burners .
C . For back to front position, the unit must be
mounted according to local building codes .
1 . Cut a hole in the bottom of the cabinet, using the
dimensions shown (FIG . 6) .
2 . Measure the remaining material of the cabinet bottom sides
(C), (FIG . 7) if it is 1/4" or more, there is no need to use
the cabinet brackets . Go to step 7 on page 9 .
3 . When there is less than 1/4" remaining material (C),
carefully remove those strips . Measure the cabinet inner
width (D) (FIG . 7) . Refer to the table below to see which
cabinet bracket edge configuration must be used .
N
arrow edge
D
From 28-1/16" to < 28-1/2"
4 . Pay attention to the Ease of Install hooks location on the
unit (distance given from unit front flange, FIG . 8) . Measure
and mark the position of the Ease of Install hooks (shown
as E in FIG . 9 on next page) on both cabinet side walls .
w
ide edge
D
From 28-1/2" to 29"
CUT A HOLE IN THE BOTTOM OF THE CABINET
A = 10¼"
HD1381
B = 28 ¹/
HD1382
UNIT TOP VIEW
8¼"
FRONT
HD1387A
FIG. 6
"
16
FIG. 7
4½"
FIG. 8
7
Publicité
