Carton Contents; Assembly - Delta 22-450 Manuel D'utilisation

The DC-580, 20" planer is shipped complete in one container mounted to a shipping skid. Remove the wooden crate from around the machine.
The planer is shipped with the motor, motor pulleys, and belts attached. Fig. 2 illustrates the loose items supplied with the machine.
A. Cutterhead Guard
B. Dust Hood
C. M6 x 1 x 12mm Button Head Screws
for fastening the cover and dust hood
to the machine (13)
For your own safety, do not connect the machine to the power source until the machine is completely
assembled and you read and understand the entire instruction manual.
Remove the bolts that fasten the machine to the shipping
skid.
Two lifting lugs are built into the machine, one of which is
shown at (E) Fig.1. These lugs can be used to mechanically lift
the machine using a forklift and lifting straps.
NOTE: The other lifting lug is located at the rear and the
opposite end of the machine. Carefully remove the planer from
the shipping skid.
Thread the handle assembly (A) Fig. 1 into the handwheel
(B) and tighten the locknut (C).

CARTON CONTENTS

B
D
H

ASSEMBLY

ASSEMBLY TOOLS REQUIRED
M6 Allen wrench (supplied)
Flathead Screwdriver (Not Supplied
Forklift and Lifting Straps For Set-Up (Not Supplied)
ASSEMBLY TIME ESTIMATE
Assembly for this machine will take approximately 1 - 2 hours
A
C
D. Knife setting gauge
E. Handwheel handle
F. 4mm T-handle wrench
G. M6 Allen wrench
H. 10 x 14mm open end wrench
E
Fig. 1
6
E
F
g
C
A
B