Delta 22-450 Manuel D'utilisation page 12

Raboteuse de 508 mm (20 po) dc-580
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

5.
To check the height of the outfeed table roller, use a feeler gauge (B) Fig. 23 to measure the gap between the table surface and the
straight edge (A) near the outfeed roller (F).
6.
To adjust, loosen the locknut (G) Fig. 24, located under the table and below the outfeed table roller (F), and rotate the adjustment
nuts (H) as necessary, to raise or lower the height of the outfeed roller (F).
NOTE: You will have to raise the table to gain access to the adjustment nuts. Tighten locknut (G) Fig. 24 after the adjustment.
7.
Check and adjust the height of the outfeed table roller on the other side of the table in the same manner.
A
F
B
HOW TO INSPECT THE ANTI-kICkBACk FINgERS
When inspecting and cleaning the anti-kickback fingers, disconnect the machine from the power source.
A series of anti-kickback fingers (Fig. 24) are provided on the
infeed end of the planer to prevent kickback of the workpiece.
These anti-kickback fingers operate by gravity and no adjustment
is required. However, You need to inspect them regularly to
see if they are free of gum and pitch and that they operate
independently and freely.
HOW TO CHECk AND ADJUST THE DRIVE BELT TENSION
Use light finger pressure on the drive belts (A) Fig. 25 midway
between the pulleys. Proper belt tension will be approximately a
1/4" deflection. To adjust:
Fig. 24
Fig. 23
Fig. 24A
12
A
g
H
A
B
Fig. 25

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

22-451

Table des Matières