Publicité
Les langues disponibles
Les langues disponibles
• An object may have covered the touch
control panel. >>> Remove the object on
the panel.
Although the hob zone is turned on, the
pot does not heat up.
• The pot may not be suitable with the In-
duction hob. >>> Check if your cooker is
suitable for the induction hob.
• The pot may not be centred correctly on
the hob zone or the bottom surface of
the pan may not be wide enough for the
selected hob zone. >>> Center the hob
zone by choosing a pot that is wide
enough for the hob zone.
The cooling fan continues to run even
though the hob is turned off.
• This is not an error. The cooling fan con-
tinues to operate until the electronic
equipment in the hob falls to the appro-
priate temperature.
Noise from the hob during cooking
• Some sounds may be heard from the
hob while cooking. These sounds are
due to the composition of the cooking
vessel. These sounds are normal, they
are not a malfunction and they are a part
of induction technology.
Error codes/reasons and possible solutions
Error codes
E 22
E 26
E 27
E 42
E 46
E 47
Possible noises and reasons
• Fan noise: The cooker is equipped with
a fan that activates automatically ac-
cording to the temperature of the appli-
ance. The fan has various operating
levels and operates at different levels as
per the temperature.
• Lower buzz like the operating noise of
a transformer: This is due to the nature
of the induction technology. As the heat
is transmitted directly to the base of the
cooking vessel, such buzz sounds may
be heard as per the material of the cook-
ing vessel. Thus, different noises may be
heard with different cookware.
• Cracking noise: The reason of this is
the structure and material of the base of
the cooking vessel. A cracking sound
may be heard if the cooking vessel is
made of various layers with different
materials.
• Whining noise: A whining sound may be
heard when two cooking zones on the
same side of the cooker are used to cook
with different cooking levels.
Error reasons
Induction hob is overheated.
A pot suitable for induction heating is
not used.
Incorrect electrical wiring connection
has been made.
One or more keys are kept pressed
for more than 10 seconds.
An object is left on the control panel
or the control is exposed to vapour.
A pot suitable for induction heating is
not used.
EN / 23
Possible solutions
Turn the induction hob off and wait
until it is cooled down. The error shall
be resolved when temperature of the
hob comes down below the limits.
The error shall be resolved when a
pot suitable for induction heating is
used.
It should be checked whether the
electrical cable connection is made
correctly according to the values
given in the technical table and the
correct connection should be made.
When the correct connection is
made, the error will disappear.
The problem shall be resolved when
you remove your hand from the hob.
The problem shall be resolved when
the control panel is cleaned.
The error shall be resolved when a
pot suitable for induction heating is
used.
EN
IT
FR
CS
Publicité
