Geberit HS50 Instructions De Montage page 25

Commissioning
Geberit Control app
The Geberit Control app is available for
commissioning, making settings and malfunction
diagnosis. The app communicates with the device
through a Bluetooth® interface.
The Geberit Control app is available free of charge
for Android and iOS smartphones in the respective
app stores.
Commission the Geberit HS50
hygiene flush unit
Prerequisite
– To use the full range of functions of the Geberit
Control app, a personal Geberit ID is required.
This can be created directly in the Geberit
Control app.
1
Scan the QR code and follow the
instructions on the landing page.
10 l/min
1234
4 l/min
2
Install and open the Geberit Control app
using a smartphone.
3
Select the HS50 hygiene flush unit under
[New end devices].
4
Establish a connection with the hygiene
flush unit.
5
Set password.
6
Configure the solenoid valves.
7
Adjust the [device settings].
8
Enter flushing programmes under
[Flush settings].
27021608432037259 © 04-2024
971.548.00.0(02)
9
Under [Information], create the
[commissioning report] and forward it to the
operator.
If the Geberit hygiene flush unit is controlled
by a building automation system or a
programmable logic controller (PLC), no
flush programmes need to be entered.
Factory settings
An interval flush is set for each solenoid valve ex
works. If no flush programmes are entered, the
hygiene flush unit works with these factory settings.
Table 1: Factory settings
Parameter Description
Flush interval Time between 2 flushes
Amount of water for one
Flush volume
1)
flush
1) With 10 l /min flow limiter
EN
Value
72 h
3 l
25