Publicité
Les langues disponibles
Les langues disponibles
MAINTENANCE
BATTERY MAINTENANCE
See Figure 39.
WARNING
hydrogen gas during normal operation. A spark or
flame can cause the battery to explode with enough
force to kill or seriously hurt you. Wear protective
clothing and a face shield, or have a skilled technician
perform battery maintenance.
WARNING
tains sulfuric acid (electrolyte) which is highly corro-
sive and poisonous. Wear protective clothing and eye
protection when working near the battery. Keep chil-
dren away from the battery.
WARNING
sparks or other sources of ignition. NEVER touch both
battery terminals at the same time with your hand or
any non-insulated tools. If battery acid contacts skin or
clothing, flush immediately with water and neutralize
with baking soda.
The battery shipped with the generator has been fully
charged. A battery may lose some charge when not in use
for prolonged periods of time.
NOTE: Once started, the generator will charge the battery
after 30 – 60 minutes of use.
When the generator is not running, the included trickle char-
ger can remain connected and will maintain the battery for
an indefinite period of time. A red light on the charger indi-
cates charging in progress. A green light indicates charging
complete. Charge in a dry location.
l Plug the charger into the battery charging port on the
control panel.
l Plug the wall receptacle end of the battery charger into
a 120 Volt AC wall outlet.
BATTERY REPLACEMENT
See Figure 40.
CAUTION
lead and lead compounds. Wash hands after handling.
l Remove the wheel in front of the battery.
l Remove the two bolts and battery plate. Tilt the battery
forward and remove.
l Disconnect the negative (–) cable (black boot) from the
negative (–) battery post.
l Disconnect the positive (+) battery cable (red boot) from
the positive (+) battery post.
NOTICE
Always connect the cables in the fol-
lowing sequence to avoid possible shock.
The battery gives off explosive
Burn hazard. The battery con-
NEVER smoke or work near
Battery posts, terminals contain
FIG. 39
A
A - Battery Charging Port
B - Charger
FIG. 40
A
A - Battery
B - Battery Plate
C - Bolt
l On the replacement battery, connect the positive (+) bat-
tery cable (red boot) to the battery positive (+) terminal.
Secure the boot over the battery post.
l Connect the negative (–) battery cable (black boot) to the
negative (–) positive terminal. Secure the boot over the
battery post.
l Install the battery in the battery tray. Install the battery
plate and bolts. Tighten the bolts securely.
NOTICE
Dispose of the used battery properly
according to the guidelines established by your local
or state government.
l Reinstall the wheel.
B
B
C
C
English | 33
Publicité
