Thermic Energy TE380234W Instructions De Montage Et D'utilisation page 30

GENERAL INSTRUCTIONS
1. Regulatory Guidelines
The assembly is based on the site conditions and must be carried out according to engineering
standards. The local regulations must be observed. The following regulations should be given spe-
cial consideration:
> DIN 18380 Heating Systems and Central Water Heating Systems
> DIN 18381 Gas, Water and Sewage Installation Systems
> DIN 18382 Electronic Cable and Power Systems in Buildings
> DIN 1988 T 1-8 Technical Rules for Drinking Water Installations / DIN EN 806 Technical Rules for
Drinking Water Installations
> DIN 4751 Safety Equipment for Heating Systems
> DIN 4753 Water Heaters and Water Heating Installations for Drinking Water
> DIN 4757 T1-4 Solar Heating Systems / Solar Thermal Systems
> VDE 0100 Installation of Electrical Equipment
> VDE 0105 Operation of Electrical Installations
> VDE 0190 Main Potential Equalisation of Electrical Systems
2. Tools Required
> Flat collet / pipe wrench
> Open-end spanner for hydraulic fittings
> Flat screwdriver / Phillips screwdriver / torque wrench / ...
> Transportation tools
> Installation tool for the water and heating connection
3. Supplementary Materials
> Sealing material:
Use of appropriately permissible sealing materials according to the respective area of
application (e.g. suitable for drinking water/solar/heating systems)
> Mounting material:
Use of appropriately permitted assembly materials for the water and heating connection
(e.g. suitable transitions, fittings, etc.)
30
Similar pictures. Subject to technical changes and changes to content, misprints and errors.