Télécharger Imprimer la page

Fox 34 STEP-CAST Guide Du Propriétaire page 7

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
ADJUST THE QUICK RELEASE
1. Note which direction the axle lever needs to turn to achieve proper
orientation.
2. Open the axle lever in the fork.
3. While holding the QR lever open and stationary so it cannot rotate, use
a 4 mm hex wrench in the center of the end of the axle to adjust the
lever position. With the 4 mm adjuster set properly, you should start
to feel tension in the axle when the QR lever is 90 degrees before full
closure in the vertical position.
4. Repeat the axle installation instructions to verify proper installation and
adjustment.
KABOLT INSTALLATION
1. Install the front wheel into the fork dropouts. Slide the
Kabolt axle through the non-drive side dropout and
hub.
2. Use a 6 mm hex wrench to torque the Kabolt axle
(clockwise) to the torque specification that is etched
on the head of the Kabolt.
7

Publicité

loading

Ce manuel est également adapté pour:

32