Publicité
Les langues disponibles
Les langues disponibles
Use hand pressure only. Never use any tool to tighten the quick release lever. Over-tightening the
levers can damage the axle or fork dropouts, leading to a sudden failure with one or more of these
components, resulting in SEVERE INJURY OR DEATH. Failure to secure the axle properly can cause
the wheel to become detached from the bicycle, resulting in SEVERE INJURY OR DEATH.
15 MM QUICK RELEASE INSTALLATION
1. Install the front wheel into the fork dropouts. Slide the axle through the non-drive side
dropout and hub.
2. Open the axle lever.
3. Turn the axle clockwise 5-6 complete turns into the axle nut.
4. Close the lever. The lever must have enough tension to leave an imprint on your hand.
5. The closed lever position must be between 1-20 mm in front of the fork leg.
6. If the lever does not have enough tension, or has too much tension when closed at the
recommended position (1-20 mm in front of the fork), see the next section for adjustment
instructions.
7. Compress the fork a couple of times to ensure that the lower leg has settled into its low-
friction point.
QR Lever Open
WARNING
QR Lever Closed
6
1-20 mm
Publicité
