Tineco PURE ONE S15 PRO Serie Mode D'emploi page 26

Status
No battery, please
charge
Brush roller is
tangled
Dust sensor
malfunction
Air channel blocked
Power is off
Start charging
Help Center
MAINTENANCE
Note:
• Clean the dustbin and filters after each use.
• To maintain high performance, wash and dry
the pre-filter monthly, replacing it every 6
months. Wash and dry the HEPA filter every 3
months, replacing it every 12 months.
Dustbin, Mesh Filter and
Pre-filter
1.Turn counter-clockwise to remove the filters.
Fig.E-1
2.Do not turn the appliance upside down when
removing or installing the filter to prevent dust
from entering the motor.
Fig.E-2
3.Clean the dustbin and mesh filter with a damp
cloth or the cleaning tool. Air dry completely
before reinstalling.
Fig.E-3
Reminder
Battery level is at 0,
please charge the
appliance
Brush roller tangled,
please clean the brush
Dust sensor malfunction,
please clean the dust on
the inner sensor
Air channel blocked,
please clean the air
channel and dustbin
Power off
Charging
Cleaning tutorial
Voice switch
Connect to network
Restore factory settings
Exit
4.The pre-filter can be washed under cold
running water and must be completely dry
before reinstalling.
Fig.E-4
5.After cleaning, insert the pre-filter into the
mesh filter properly and it clicks into place.
Install the clean filters back into the main body,
then close the dustbin flap.
Fig.E-5
HEPA Filter
1.Pull out the HEPA filter (in magnetic design) for
cleaning. Do not use the appliance without first
installing the HEPA filter.
Fig.E-6
2.The HEPA filter can be washed under cold
running water and must be completely dry
before reinstalling.
Fig.E-7
Dust Sensor
• To avoid dust accumulation which can affect
cleaning performance, wipe the suction mouth
with a damp cloth.
Fig.E-8
Mini Power Brush
1.Press against the roller end cover downward.
Fig.E-9
2.Pull out the brush roller.
Fig.E-10
3.Remove the debris wrapped around the roller
with the Tineco Hair Cleaning Tool.
Fig.E-11
4.Fully reinsert the brush roller at an angle and
push upward until it clicks securely back into
place.
Fig.E-12
Brush Head
1.With the power off, slide the switch to open
the brush roller end cover, and rotate it
counter-clockwise to pull out the brush roller.
Fig.E-13
24