Publicité
Les langues disponibles
Les langues disponibles
English
Monitoring Channels
To enter the Monitor mode and listen for weak signals on the current
channel, press and hold the Scan/Monitor button for three seconds.
NOTE: You can also listen to the volume level of the radio
when you are not receiving calls. If necessary, you can adjust
the volume.
Setting the Volume
Perform one of the following actions:
To increase volume, turn the Power/Volume knob clockwise.
●
To decrease volume, turn the Power/Volume knob
●
counterclockwise.
To adjust the headset volume connected over Bluetooth, refer to
Connecting Bluetooth Headset-to-Radio
CAUTION: Do not hold the radio close to your ear. If the
volume is set to an uncomfortable level, it could hurt your ear.
Setting and Transmitting Call Tones
Your radio can transmit different call tones to other radios in your group.
Call tones allow you to alert other radios when you want to talk. Your
radio has 20 call tones to choose.
1. Press the Menu/Lock button until the Call Tone icon appears.
The display shows the current call tone setting.
2. To change and listen to the call tones, press the + or - button.
NOTE: Setting the call tone to 0 disables the call tone feature.
3. To set the new call tone and exit Menu, press the PTT button.
You can continue the set-up by pressing the Menu/Lock button.
4. To transmit your call tone to other radios with the same channel and
Interference Eliminator Code, press the Call Tone button.
Setting the Keypad Tones
You can enable or disable the speaker key tones. You hear the key tone
each time you push a button.
1. Press the Menu/Lock button until the radio displays Keypad Tone
icon.
12
on page 14.
The current on/off setting blinks.
2. To turn on or off keypad tones, press the + or - button.
3. To confirm and exit menu, press the PTT button.
You can continue the set-up by pressing the Menu/Lock button.
NOTE: The following features are not disabled when the keypad
tone feature is turned off:
Transmit timeout alert tone.
●
Call tone.
●
Low battery alert tone.
●
The transmitted talk confirmation tone.
●
Transmitting a Talk Confirmation Tones
You can set your radio to transmit a unique tone when you finish
transmitting, similar to saying "Roger" or "Over" to let others know you
are finished talking.
1. Press the Menu/Lock button until the radio displays Roger Tone
icon.
The current setting blinks.
2. To turn the confirmation tone on or off, press the + or - button.
3. To confirm and exit menu, press the PTT button.
You can continue the set-up by pressing the Menu/Lock button.
Turning LED Flashlight On or Off
1. To turn the light on, press the Flashlight button.
2. To turn the light off, press the Flashlight button again.
NOTE: You can turn off the flashlight when not in use to
conserve battery power.
Locking or Unlocking the Keypad
1. To prevent accidental changes to the settings, lock the keypad by
pressing and holding the Menu/Lock button until the radio displays
the Keypad Lock icon.
When in lock mode, you can turn the radio on and off, adjust the
volume, receive, transmit, send a call tone, send the Emergency
Alert, turn the LED flashlight on and off, and monitor channels. All
other functions are locked.
Publicité
