Publicité
Les langues disponibles
Les langues disponibles
3. Remove the grease plug.
4. Look into the grease plug hole and turn the drive
shaft. The grease level (A) must be in level with the
top of the gear cogs (B).
A
User interface
Problem
Battery LED indicator flashes or-
ange
Error LED flashes red
The product does not start
Error LED is lit with red light
1920 - 002 - 16.05.2024
B
Troubleshooting
Possible faults
Low battery voltage.
Overload.
Temperature deviation.
The power trigger and the acti-
vate button are pressed at the
same time.
Dirt in the battery connectors.
The product needs servicing.
5. If the grease level is too low fill the bevel gear with
Husqvarna bevel gear grease. Fill slowly and turn
the drive shaft as you apply the bevel gear grease,
stop at the correct level (B).
CAUTION:
grease can cause damage to the bevel
gear.
6. Install the grease plug.
Possible action
Charge the battery.
The cutting attachment is jammed. Stop the
product. Remove the battery. Clean the cut-
ting attachment from unwanted materials.
Let the product cool down.
Release the power trigger and the product is
active.
Clean the battery connectors with com-
pressed air or a soft brush.
Contact your servicing agent.
An incorrect quantity of
17
Publicité
