Husqvarna 525iLST Manuel D'utilisation page 16

The following is a list of the maintenance steps that you
must do on the product. Refer to
maintenance on page 11 for more information.
Maintenance
Clean the external parts of the product with a dry cloth. Do not use water.
Examine that the start and stop button works correctly and is not damaged.
Make sure that the power trigger and the power trigger lockout function correctly
from a safety point of view.
Make sure that all controls work and are not damaged.
Keep the handles dry, clean and free from oil and grease.
Make sure that the cutting attachment is not damaged. Replace the cutting
attachment if it is damaged.
Make sure that the cutting attachment guard is not damaged. Replace the cut-
ting attachment guard if it is damaged.
Make sure that the screws and nuts are tight.
Make sure that the battery release buttons on the battery works and locks the
battery in the product.
Examine that the battery charger is not damaged and function correctly.
Make sure that the battery is not damaged.
Make sure that the loop handle is not damaged and attached correctly.
Make sure that the blade is correctly centered, is sharp, and not damaged. An
off-center blade will cause vibration that could result in damage to the product.
Make sure that the locknut of the cutting equipment is tightened correctly.
Make sure that the transport guard for the blade is not damaged and that the
transport guard can be attached correctly.
Examine all couplings and connections. Make sure they are not damaged and
free from dirt.
Make sure that the bevel gear is filled correctly with grease, refer to
the bevel gear on page 16 . If not, use Husqvarna bevel gear grease.
Lubricate the drive shaft end in the lower shaft coupling.
Make sure that the air intake of the motor is not dirty. Clean the air intake with
compressed air.
Do a check of the connections between the battery and the product. Do a check
of the connection between the battery and the battery charger.
To clean the product, the battery and
the battery charger
1. Clean the product with a dry cloth after use.
2. Clean the battery and battery charger with a dry
cloth. Keep the battery guide tracks clean.
3. Make sure that the terminals on the battery and the
battery charger are clean before the battery is put in
the battery charger or the product.
16
Safety instructions for
To lubricate
To lubricate the bevel gear
1. Remove the cutting equipment.
2. Put the product with the grease plug at its highest
position.
Daily Weekly Monthly
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
X
1920 - 002 - 16.05.2024
X