Husqvarna 525iLST Manuel D'utilisation page 13

To attach the trimmer head
1. Make sure that the cutting attachment guard (A)
is attached to the product. Refer to
cutting attachment guard on page 12 .
2. Make sure that the drive disc (C) is attached to the
output shaft (D).
3. Put the locking pin (B) in the hole to lock the shaft.
4. Put the trimmer head (E) on the output shaft.
Introduction
WARNING:
safety chapter before you use the product.
Husqvarna Fleet Services
Husqvarna Fleet Services
gives the commercial fleet manager an overview of all
products. Husqvarna Fleet Services
525iLST. For more information about Husqvarna Fleet
™
Services , refer to www.husqvarna.com.
®
Bluetooth wireless technology
Products with built-in Bluetooth
can connect to mobile devices and enables additional
functions.
Bluetooth
The symbol for
on when your mobile device is connected to the product.
To connect to the product with Husqvarna
™
Fleet Services
1. Download the Husqvarna Fleet Services
your mobile device.
2. Log on to the Husqvarna Fleet Services
3. Follow the instructions about how to pair the product
with Husqvarna Fleet Services
1920 - 002 - 16.05.2024
To attach the
D
C
B
A
Read and understand the
™
™
is a cloud solution that
™
can be added to
®
wireless technology
®
wireless technology comes
™
app to
™
app.
™
.
5. Turn the trimmer head (E) counterclockwise to
tighten it to the output shaft.
6. Remove the locking pin.
Operation
To connect the battery to the product
WARNING:
original batteries with the product.
1. Make sure that the battery is fully charged.
2. Push the battery into the battery holder of the
product. The battery locks into position when you
hear a click.
3. Make sure that the battery is installed correctly.
Work position
• Hold the product with 2 hands.
• Hold the product on the right side of your body.
• Keep the cutting attachment below waist level.
• Keep body parts away from the hot surfaces.
E
Only use Husqvarna
CAUTION:
If the battery does not
move easily into the battery holder, the
battery is not installed correctly. This can
cause damage to the product.
13