Parkside PSHP 1 A1 Consignes D'utilisation Et De Sécurité page 6

List of pictograms used
Caution! Read the operating
instructions!
Do not dispose of any
electrical devices in
domestic waste!
Attention: Welding helmets
do not offer any form of
protection for the eyes, ears
or face!
Made from recycled material
Dispose of the device
and packaging in an
environmentally friendly
manner!
Automatic welding helmet
PSHP 1 A1
 Introduction
Congratulations! You have
purchased one of our high-
quality devices. Please familiarise
yourself with the product before using it for
the fi rst time. To do so, please read through
the following operating and safety instruc-
tions carefully.
KEEP OUT OF THE REACH OF
CHILDREN!
 Intended use
When welding, this welding helmet protects
the eyes and face from sparks, splashes and
UV radiation and automatically adjusts to
the lighting conditions.
It ensures immediate, sensor-controlled
darkening when the arc is ignited as well as
6 GB/IE/NI/CY/MT
Warning: Potential hazards!
Important note!
Attention: Arc beams can
damage the retina of the eye!
Dispose of batteries in an
environmentally friendly
manner!
Direct current
automatic lightening when welding work is
fi nished (including short delay for protection
against afterglow). The welding helmet has
an infi nitely adjustable DIN protection level
with side adjustment wheel and can also be
set for fl ying sparks during grinding work.
Use the product only as described and only
for the specifi c applications as stated. Keep
these instructions in a safe place. Ensure
you hand over all documentation when
passing the product on to anyone else. Any
use that differs to the intended use as stated
above is prohibited and potentially danger-
ous. Damage or injury caused by misuse
or disregarding the above warning is not
covered by the warranty or any liability on
the part of the manufacturer. The device has
been designed for household use only and
must not be used in commercial or industrial
applications.