Publicité
Page 6 of 15
Picture 21
•
Remove the seat using the key
•
Remove the 3 bolts arrowed in Picture 1 using 4mm Allen key and a Phillip screwdriver.
•
Starting from the LHS of the bike, loosen the two bolts arrowed in Picture 2 using a 6mm Allen
key. It is not necessary to remove the bolts completely. Repeat the procedure for the RHS
bolts.
•
Remove the four bolts arrowed in picture 3. Gently pull the side panels aside and remove the
four bolts using 8mm socket and a wrench as shown in picture
4. Remove the seat lock bracket.
•
Disconnect all tail unit connectors as arrowed in picture 5. Please note the orientation of the
connectors. Cut the cable tie that holds all the wiring (Labelled A in Picture 5).
•
Remove the four nuts arrowed in Picture 6 using a 10mm socket and a wrench. Keep the tail
unit supported at this stage while undoing the nuts. Gently withdraw the whole tail unit
assembly and the wiring off the sub-frame.
•
On the OEM tail unit assembly, remove the plastic cover located on the centre underside of the
bracket. Unclip the two clips arrowed in Picture 7 and withdraw the plastic cover.
•
Remove the four bolts arrowed in Picture 8 using a 4mm Allen key. Keep the OEM licence plate
bracket supported at this stage. Remove the bracket once all bolts are removed as shown in
Picture 9.
•
Remove the four screws arrowed in Picture 10 using a Phillip screwdriver. Remove the bracket
as shown in Picture 11.
•
Remove the spreader/ clamp plate on each indicator as shown in Picture 12.
•
Remove both indicators from the OEM tail unit as shown in Picture 13.
•
From the kit, take the R&G Licence plate bracket (Item 1) and fit both indicators as original to
the bracket.
•
From the kit, take the OEM indicator adaptor (Item 4) and fit it on the inside of the indicator
stem as shown in Picture 14. Repeat the procedure to the other indicator. Shown in Picture 15.
•
From the kit, take the licence plate illuminator (Item 3) and fit it through the three in-line holes
located in the top centre of the Licence plate bracket (Item 1). Secure with M3 washers and
nuts provided as shown in Picture 16.
•
Take Licence plate illuminator shroud & apply a small amount of super glue on the inside and
place it over the licence plate illuminator (Item 10).
•
When all the lights are fitted it should look as the picture shown in Picture 17.
Unit
Tel: +44 (0)
420 89007 Fax: +44 (0)
1
Cover Plate
License Plate
Bracket
FITTING INSTRUCTIONS
, Shelley's Lane, East Worldham, Alton, Hampshire, GU34 3AQ
1
420 87301 www.rg-racing.com Email: info@rg-racing.com
1
R&G
Picture 22
LP0373
Publicité
