Gardeo GTDTAL58HP5TBS-CM Traduction Des Instructions Originales page 60

• check the grass catcher frequently for wear or deterioration
SERVICING
Genuine spare parts are supplied by service workshops and by many dealers. We recommend that you take
the machine to an authorized service station for annual servicing, maintenance and inspection of safety
equipment. For service and spare parts, please contact the dealer where the machine was purchased.
The noise test code is EN 3744 Engineering method (grade 2)
The vibration test code is EN 1033 for hand push type mower.
Engine Maintenance
Check Engine Oil Level
Check the engine oil level with the engine stopped and the mower.
Remove the oil filler cap, and wipe the dipstick clean.
Insert the dipstick into the oil filler neck, but do not screw it in.
Check the oil level shown on the dipstick. If near the lower, fill to the upper level with the oil. Do
not overfill.
Screw in the filler cap securely.
Oil tank : 0.6L SAE 10W-30
NOTICE: Running the engine with a low oil level will cause engine damage.
Change Engine Oil
Drain the used oil while the engine is warm. Warm oil drains quickly and completely.
Wipe the oil filler area clean, then remove the oil filler cap/dipstick.
Place a suitable container next to the mower to catch the used oil, then tilt the mower on its right
side. The used oil will drain through the filler neck. Allow the oil to drain completely.
60