Siemens EQ.300 TI353 Serie Mode D'emploi page 26

en Trouble shooting
The brewing unit cannot be
removed.
The appliance cannot be oper-
ated, display messages chang-
ing.
The grinder will not start.
Display shows "Close door"
despite door being closed.
Display shows: "Empty trays"
despite empty drip tray - what
to do?
Display shows "Fill water tank"
despite full water tank.
26
The brewing unit is not in the
removal position (e.g. frost pro-
tection activated).
The appliance is in demo mode. Hold k button for at least 5 seconds
The appliance is too hot.
The door is not closed properly. Press the door firmly closed.
The appliance is too hot.
Emptying is not detected when
the appliance is off.
Water tank wrongly inserted.
Carbonated water in the water
tank.
Float is stuck in the water tank. Remove the water tank and clean thor-
New water filter not rinsed
according to the instructions.
Air in the water filter.
Water filter is old.
Limescale deposits in the water
tank can block up the system.
Switch the appliance on again.
to deactivate demo mode. Remove the
water tank, fill with fresh water and
re-insert.
Disconnect the appliance from the
mains and leave to cool down for
1 hour.
Disconnect the appliance from the
mains and leave to cool down for
1 hour.
When the appliance is switched on,
remove and re-insert the drip tray.
Insert water tank correctly.
Fill the water tank with fresh tap water.
oughly.
Rinse the water filter according to the
instructions and then switch on.
Immerse the water filter (opening up)
in water until no more air bubbles
escape; insert the filter again.
~ "Inserting or replacing a water
filter" on page 17
Insert a new water filter.
Clean the water tank, add 0.5 l water
and allow a Siemens descaling tablet
to dissolve completely. Switch the
appliance off and on again so the des-
caling solution is pumped into the sys-
tem. Wait 3 minutes. Repeat the
process.Check whether the appliance
starts. Clean the water tank thoroughly
and start calc'nClean.
~ "Calc'nClean service programme"
on page 23