Publicité
Les langues disponibles
Les langues disponibles
electrical information
EN
5.5
initializing the transmitter for the first time
WARNING
!
•
Ensure the gas and electrical power to the appliance is turned off.
Locate the transmitter and receiver supplied with the appliance.
A.
Make sure the slide switch on the receiver is set to the "OFF" position.
B.
Press the battery compartment slightly into the receiver and release enabling the battery compartment to
C.
pop out. (Fig. 1).
Place 4 "AA" batteries into the battery compartment and slide the compartment back into the receiver.
D.
(Fig. 2).
Connect the receiver wires to the two leads from the control module, identified as switch wires. See
E.
"wiring diagram" section.
Place 2 "AAA" batteries into the battery compartment of the transmitter (Fig. 3).
F.
Slide the switch on the receiver to the "REMOTE" position. The low battery indicator on the
G.
receiver will flash and the receiver will beep twice. The receiver is now ready to communicate with the
transmitter. You only have 30 seconds after the receiver is put in the "REMOTE" position to
capture the code, which will be indicated by three beeps from the receiver.
Point the transmitter at the receiver, push and hold the "ON" button for 1 to 2 seconds to capture a
H.
predetermined code. The low battery indicator on the receiver will fl ash and the receiver will beep three
times to confirm synchronization with the transmitter. At this time the remote should be fully operational.
TRANSMITTER
46
W415-2944 / B / 05.22.24
BATTERY
INSTALLATION
BA T.L OW
STICKER
(See 7. FINISHING)
BATTERY
COMPARTMENT
FIGURE 1
RECEIVER
FIGURE 2
TRANSMITTER
°F
°C
AAA
AAA
BATTERY
COVER
FIGURE 3
Publicité
