BECKER-Antriebe BECK-O-TRONIC 4 Instructions D'installation Et D'entretien page 23

1-channel
hand transmitter
In order to log off (delete) the radio hand transmitters, keep the radio PRG button
pressed down until the control switches back to standby mode. In this process, all of
the radio hand transmitters previously logged on are deleted. You can reactivate them
by logging on again.
Programming of the radio hand trans mitter
1. Open the lid of the control by loosening the 4
2. Briefly press the radio PRG button at the bot-
3. The control can be programmed for 1-chan-
4. You can switch between 1-channel and 4-
5. Select desired mode and:
A 1-channel radio hand transmitter cannot
be programmed in 4-channel mode.
After the radio hand transmitter has been success-
fully logged on, the control automatically switches
back to operating mode ("operation" status dis-
play lights up) and your radio hand transmitter is
ready for operation. According to this method you
4-channel
can program a total of fifty hand transmitters (1-
hand transmitter
channel or 4-channel).
6. Close the control housing again.
lid screws and fasten it to the control hou sing
as in the adjacent picture.
tom right of the control device.
nel mode when the "operation" status display
(left-hand lamp) flashes.
channel programming mode by pressing the
radio PRG button again. Programming mode
for 4-channel mode is signalised by all four
status displays flashing at once.
in 1-channel mode press the desired button on
the radio hand transmitter
or
in 4-channel mode press the "DOWN" button
on the radio hand transmitter.
Note
DE
GB
FR
NL
23