Radio Hand Transmitter - BECKER-Antriebe BECK-O-TRONIC 4 Instructions D'installation Et D'entretien

Operating Instructions
Checking:
Pneumatic safety edges are checked for safety reasons during every downward move-
ment. This process is called checking or testing.
"STOP" button
The door is stopped if the "STOP" button is pressed. If the control has been set for the
light mode, the light can be switched on via the "STOP" button.
"UP" button :
The door opens when the "UP" button is pressed unless it is already in the upper end
position. If the door is moving down, it can be stopped with the "UP" button.
"DOWN" button
The door closes when the "DOWN" button is pressed, unless it is already in the lower
end position. If the door is moving up, it can be stopped with the "DOWN" button.
Note
Door movement is not possible while the "STOP" button is pressed or while a
safety device has triggered in the emergency stop circuit.
1-channel hand transmitter
Button with
impulse
sequence
UP- STOP-
DOWN-
STOP
4-channel hand transmitter
UP button
STOP button
22
":
:

Radio hand transmitter

The door system can be operated by remote
control with a 1-channel or 4-channel radio hand
transmitter. This means that the control has to
be fitted with a radio receiver and the hand radio
transmitter has to be logged on to the control. The
control with a plug-in radio receiver supports two
different radio modes:
1-channel mode:
With the aid of the radio hand transmitter, the door
can be operated in the following sequence (UP-
STOP-DOWN-STOP, etc.) by remote control.
4-channel mode:
With the aid of the 4-channel radio hand transmit-
ter, the door can be operated via defined com-
LIGHT button
DOWN button
mands. The buttons of the 4-channel radio hand
transmitter are assigned as in the picture on this
page.