Li- Wine Cabinet Layout Advice; Lii- Adding Sliding Shelves - Eurocave 92 Série Mode D'emploi

Table des Matières

Les langues disponibles

Your EuroCave cabinet was designed to accept more than one type of storage shelf. Depending on the model, it adapts to your requirements and different

types of shelves can be added:

I - Different types of storage shelves

Universal storage shelf

Ref: AXUH

Capacity: 77 bottles

Max. weight: 100 kg

Bordeaux storage shelf

Ref: AXBH

Capacity: 78 bottles

Max. weight: 100 kg

Display shelf

Ref: ACPH

Capacity: 22 bottles

II - Wine cabinet layout advice

Your EuroCave wine cabinet was designed to safely hold a maximum number of bottles. We recommend that you follow the advice below in order to

optimise storage.

- Ensure that you distribute your bottles as evenly as possible over the various shelves in your cabinet to ensure even weight distribution. Also make sure

that your bottles are not touching the back wall of the cabinet.

- Also ensure that you distribute your bottles evenly over the height of the wine cabinet (loading all bottles at the top or all bottles at the bottom should

be avoided).

- Ensure that you pay attention to the instructions specific to your cabinet model with regard to storage, and never stack bottles on a sliding shelf.

- If you have sliding shelves, it is recommended that you position them in the upper section of your cabinet to facilitate daily access to them.

- Likewise, keep one or two bottles of each of your different wines on the sliding shelves and keep any surplus bottles on the storage shelves. Then, when

you drink a bottle, simply replace it with one from the storage shelf.

- When using your wine cabinet, never pull out more than one sliding shelf at a time.

N.B.: Never change the position of the stiffener(s) fitted in your cabinet (see description, page 5) without first

consulting your retailer, and never move this part when your cabinet is loaded.

III - Adding sliding shelves

When you purchase your cabinet, the sliding shelves are set to perfectly fit the interior dimensions of your appliance. If you purchase a new sliding shelf,

you may have to set the shelf to the desired fit yourself. To do so, unscrew the screws of the first right or left slider (2 screws) then position the slider at

the desired width and screw the screws back on. Repeat the procedure for the second slider (if necessary):

Slider

The "Main Du Sommelier" supports can be changed or replaced. You can also add a thirteenth support:

- Gently detach (1) the oval section of the support and pull it (2) towards the shelf rods.

To adjust the shelf for a new layout: gently slide the supports along the shelf. They must remain in staggered rows so that the bottles are correctly

positioned.

6- l

Adjustment screw

Slider

- s

ayout

Universal sliding