Charging Batterie - lopital Elexo XXL Mode D'emploi

In order to avoid injuries, we advise the carer to place
the bucket before the client takes a seat on the chair.
The Lopital plastic bedpan, stainless steel bedpan
and bucket must be cleaned and disinfected after
use, for example in a bedpan washing unit.
If the Lopital plastic bedpan, stainless steel bedpan
or bucket has been used, it must be removed from the
chair before the chair is moved or adjusted in height.
3.7. Charging battery
• The Elexo XXL is an electrically driven high / low
shower-toilet chair and works on a battery.
• The charging point is located on the front of the chair, on the
blue cover on the underside of the device (See figure 14).
• If the battery is almost completely empty of charge, the
orange light on the manual control will come on; this
means that the battery needs to be charged.
• If the LED is on continuous red, the battery must be charged
immediately. The chair can then no longer be used.
• Connect the charger to the Elexo XXL (See figure 14).
• Once the charger is connected to the Elexo XXL, the controls
will go into 'sleep' setting (all functions are switched off).
Make sure that you push the plug into the correct position in the charging
point.
Only the original charger for the Elexo XXL may be used. If you use another
charger, Lopital cannot be held liable for any consequences, such as damage to
the electronics.
Once the charger is connected to the Elexo XXL, the controls will go into 'sleep'
setting (all functions are switched off).
The charger that must be used for the Elexo XXL is the 'Mascot 2241'.
Elexo XXL Shower-toilet chair | Instructions for use | 35
Figure 13 Stainless steel
bedpan, back.
Figure 14 Charging point.