Pelgrim CKT845 Notice D'utilisation page 71

Connecting the appliance to the power mains
Important warnings
• The appliance may only be connected by an authorized skilled technician.
• Electric system protection should comply with all relevant regulations.
• The connection clips can be accessed when the connection clip covers are opened / removed.
• Before connecting the appliance, make sure the voltage indicated on the rating plate is consistent
with the voltage in your home circuit.
• The rating plate with basic information is attached on the lower side of the hob.
• The electric circuit should also include an omnipolar switch that will separate the appliance from
the mains, if required, with at least 3 mm of distance between contacts. Suitable devices include
fuses, current protection switches, etc.
• The connection should be selected according to the installation possibilities with regard to current
and fuses.
• Given the protection from the risk of fi re, appliances of this type may be installed in a worktop
next to a piece of kitchen furniture that is taller than the appliance (when installed); however, in
this case, a kitchen furniture not higher than the cooking hob must be installed on the other side,
adjacent to the appliance.
• The current conducting and isolated parts must be protected from any possibility of direct contact.
ATTENTION!
• Before any manipulation with the appliance (other than its regular use), disconnect it from the
power mains. The appliance should be connected according to the relevant scheme (diagram),
subject to the network voltage. Connect the earth (PE) wire to the clip indicated with the earth
/ground symbol.
• The mains cord must be fed through the fastening clip / strain release device which protects it
from being pulled out accidentally.
• After connecting the appliance, turn on all cookers for approximately three minutes to check their
operation.
• The worktop should be installed completely horizontally.
• The cutoff surfaces should be appropriately protected.
• Use the supplied screws [2] (4x - SVK6...600 mm;
6x - SVK7...750 mm;) to secure the fi xing brackets [1]
(4x - SVK6...600 mm; 6x - SVK7...750 mm;) to the bottom of
the cooker where appropriate holes [3] have been prepared for
this purpose.
• Insert the cooking hob into he cutoff and press it heavily from
above against the worktop.
• For screwing down the fi xing clip it is not allowed to use
screws longer than 6,5 mm.
• Connect the cooking hob to the power mains (see instructions
for connecting a cooking hob on a power network).
71