Télécharger Imprimer la page

Pelgrim CKT845 Notice D'utilisation page 69

Publicité

Les langues disponibles

Les langues disponibles

Installation
Important warnings
• Installation of the appliance into a kitchen worktop and its connection to the power mains may only be
performed by an adequately qualifi ed technician.
• Veneer or other fi nish of the piece of kitchen furniture into which the hob is to be built in should be
treated with heat resistant glue (100°C); otherwise, the worktop fi nish may be discolored or deformed.
• Cooking hob is dimensioned to be built into the worktop over a piece of kitchen furniture, with a width
of 600 mm or more.
• After installation, the front two fastening elements should be freely accessible from below.
• Hanging, or wall-mounted kitchen elements should be installed high enough not to interfere with the
work process.
• The distance between the cooking hob and the kitchen hood should be no less than indicated in the
instructions for kitchen hood installation. The minimum distance is 650 mm.
• The distance between the appliance edge and the adjacent tall kitchen furniture element should
amount to no less than 40 mm.
• Use of massive wood decoration plates or boards on the worktops behind the cooking hob is
permitted, if the minimum distance remains the same as indicated in the installation drawings.
• Minimum distance between the built-in cooking hob and the rear wall is indicated on the installation drawing.
Installing the foam
gasket
Before inserting the appliance into the opening in the kitchen
worktop, the supplied foam gasket must be attached to the lower
side of the glass ceramic (glass) cooking hob (see fi gure above).
Do not install the appliance without the foam gasket!
The gasket should be attached to the appliance in the
following way:
- Remove the protective fi lm from the gasket.
- Then, attach the gasket to the lower side of the glass,
approximately 2-3 millimetres from the edge (as shown in the
fi gure). The gasket must be attached along the entire length of
the glass edge and should not overlap at the corners.
- When installing the gasket, make sure that the glass does not
come into contact with any sharp objects.
NOTE!
On some appliances the gasket is already installed!
69

Publicité

loading

Ce manuel est également adapté pour:

Ckt855Ckt870