Philips HR2171 Mode D'emploi page 10

EnglisH
10
Never use the pulse setting longer than a few seconds at a time.
- To crush ice, press the ICE button.
Tip: You can see the result thorough the transparent lid.
3 When you have finished processing, set the control knob to 0 and unplug the appliance.
Always set the control knob to 0 before your open the lid.
tips
- To prevent spillage, do not put more than 1.5 litres of liquid in the blender jar, especially when
you process at a high speed. Do not put more than 1 litre in the blender jar when you process
hot liquids or ingredients that tend to foam.
- You can use the opening in the lid to add ingredients while the appliance is running (Fig. 7).
- Do not process dry ingredients for more than 1 minute.
- Cut solid ingredients into smaller pieces before you put them in the blender jar. Do not process
a large quantity of solid ingredients at the same time. Process these ingredients in a series of
small batches instead.
- If you are not satisfied with the results when you blend solid ingredients, use the pulse setting a
few times to let the blender run briefly. If you want to use a spatula, switch off the appliance,
open the lid and then stir the ingredients. You can also remove some of the contents of the jar
and process smaller amounts.
- To crush ice cubes, put max. 5 cubes in the jar at a time and press the ICE button a few times.
HR2171 only: The jar is made of stainless steel. Do not drop the jar on a hard floor. Avoid
extreme thermal shocks. HR2170 only: The jar is made of glass and therefore breakable. Do not
drop the jar on a hard floor. Also avoid extreme thermal shocks. If the jar is very cold, rinse it
well with lukewarm water before you pour hot liquid into it. If the glass jar cracks, stop using it.
Filter (HR2168/HR2167 only)
You can use the filter to obtain extra finely blended sauces, fresh fruit juices or cocktails. All pips and
skins are caught in the filter.
HR2170/HR2160: You can order the filter (type number HR2963) from your Philips dealer.
Never fill the filter beyond its metal part.
Do not use the filter to process hot ingredients.
preparing the filter for use
1 Assemble the blender jar onto the motor unit (see section 'Preparing the blender for use' in
this chapter).
2 Put the filter in the blender jar (Fig. 8).
Make sure the filter is placed properly on the bottom of the jar.
The grooves of the filter and the ribs inside the blender jar help you put the filter in the right
position.
3 Close the lid.
using the filter
1 Put the ingredients in the filter through the opening in the lid.
Cut fruits into smaller pieces and soak dried pulses, such as soy beans, before you process them in
the filter.
2 Add water or another liquid.