MINN KOTA MKR-28 Mode D'emploi page 5

7
q. Turn the entire assembly to the right or left until the
Cord from the Plug Assembly is in an acceptable
location. Check for clearance of other items on the
mounting surface and if the cord will interfere with the
operation of anything in the area.
Make sure the location also allows for the
NOTICE:
Plug to be connected and disconnected. Then the
Locking Collar can be secured once the Plug is in use.
r. Once in an acceptable location, take a pen or marking
tool and mark the mounting surface in each of the
screw holes on the Face Plate. Make note of the
orientation of the Plug for correct placement in the
next steps of installation. With the locations marked,
remove the Plug Assembly from the Plug Receptacle
and set it aside.
s. Lift the Plug Receptacle, Face Plate and wires forward
out of the drilled hole and leave it hang out of the way.
Take a Drill with an 1/8" Drill Bit and drill pilot holes
into the Mounting Surface on the Marked Locations.
8
ITEM(S) NEEDED
#32 x 4
t. With pilot holes drilled, push the wires, Face
Plate and Plug Receptacle back in place on the
Mounting Surface.
u. Double check the location of the Hook on the back
side of the Face Plate. The Loop in the cable of the
Dust Cover should be placed in the Hook of the Face
Plate. Once secure, push the Face Plate all the way
back against the mounting surface. Ensure the Plug
Receptacle is positioned as previously noted.
v. Realign the drilled pilot holes with the screw holes on
the Face Plate. Secure the Face Plate with four #8-18
x 1-¼ Screws (Item #32) using a Phillips Screw Driver.
5 | minnkotamotors.com
7q
Cord Cord
Plug Plug
7s
Receptacle Receptacle
Marked Marked
Location Location
Face Face
Plate Plate
Marked Location Marked Location
Hook Hook
8u
Dust Cover Dust Cover
Loop Loop
8v
Face Face
Plate Plate
Marked Location Marked Location
7r
Marked Location Marked Location
Plug Assembly Plug Assembly
Face Face
Plate Plate
©2022 Johnson Outdoors Marine Electronics, Inc.
Face Face
Plate Plate