Publicité
Les langues disponibles
Les langues disponibles
5
k.
Once the Splicers are secure on both wires, take the
Shrink Tubes and slide them over the Splicers. The
Shrink Tube should be centered over the Splicer and
completely cover the wire connections.
l.
When satisfied with the position, secure the Shrink
Tubes in place with a Heat Gun. Ensure that there is
no opening around the Shrink Tubes when heated.
Push the wires and the Plug Receptacle into the
drilled hole until the Plug Receptacle sits against
the mounting surface.
The Shrink Tubes are meant to water
NOTICE:
proof the connection between the Plug Receptacle
and the Boat Wires. Make sure there are no gaps
around the wires that would allow water to reach
the connection.
6
ITEM(S) NEEDED
#2 x 1
m. The Face Plate (Item #2) is keyed with the Plug
Receptacle. Turn the Face Plate over and notice the
notches along the Inner Circle. These notches are
keyed with the outer edge of the Plug Receptacle
when it sits flush on the mounting surface. This allows
the Face Plate or Plug Receptacle to be rotated in 45
degree increments.
Tethering the Dust Cap to the Face Plate
NOTICE:
during installation is optional. The Dust Cap can be
stowed away when the plug is in use and should be
replaced for storage or transport.
n.
On the back side of the Face Plate, there is also
a hook to attach the Dust Cover (Item #C). Determine
if the Dust Cover will hang to the right or the left and
turn the hook on the Face Plate to the appropriate
direction.
o.
Flip the Face Plate so the keys on the Inner Circle
are towards the mounting surface and place it over
the Plug Receptacle. It should be seated on the
mounting surface.
p.
Take the Plug Assembly (Item #A) and plug it into
the Plug Receptacle. The Plug Assembly and Plug
Receptacle are also keyed with each other. Orientate
the Plug Assembly and Plug Receptacle so they can
be fully pushed together. The Threaded Collar on the
Plug Assembly does not have to be tightened.
4 | minnkotamotors.com
5k
Shrink
Shrink
Tubes
Tubes
#C x 1
6m
Plug Receptacle
Plug Receptacle
6n
6o
Mounting Surface
Mounting Surface
NOTICE:
insure optimal water-tight protection to electrical contacts.
Plug Receptacle
Plug Receptacle
#A x 1
Inner Circle
Inner Circle
Face Plate
Face Plate
(back)
(back)
Loop
Loop
Hook
Hook
Dust Cover
Dust Cover
Plug
Plug
6p
Receptacle
Receptacle
Face Plate
Face Plate
(front)
(front)
Face Plate
Face Plate
Mounting
Mounting
(front)
(front)
Plug Assembly
Plug Assembly
Use the Dust Cap when the plug is not in use to
©2022 Johnson Outdoors Marine Electronics, Inc.
Face Plate
Face Plate
(back)
(back)
Plug
Plug
Receptacle
Receptacle
Threaded
Threaded
Collar
Collar
Surface
Surface
Publicité
