Reset To Default Settings; Preparation For Training - Ambu Cardiac Care Trainer System W Mode D'emploi

An overview of the different LED status can be seen in the following table:
LED status
Green steady
Green slow flashing
Green fast flashing
Off

4.2.3 Reset to default settings

To reset the manikin into the default settings press the power button for more than 10
seconds. The manikin will reboot with the default settings.
Detailed information about the default settings can be found in the Directions for use for
the Ambu CPR-Software.

5. Preparation for training

The manikin is supplied in a portable suitcase. Open the suitcase and take out the
manikins and legs.
5.1 Mounting the legs on the torso ③
Pull down the trousers a little around the hips. Place the legs in a position so that the 2
dowels on the hip part can slide into the corresponding dents at the bottom of the
manikin's body, see 3.1.
Press the two Velcro straps firmly to the body, see 3.2.
To remove legs pull off the Velcro straps and the legs will be disengaged.
5.2 Monitoring Instrument
Activate the instrument by depressing the catch. In case the instrument is not activated
(pulled out), no damage is done to the manikin nor to the instrument during chest
compression.
5.3 Adjusting chest stiffness ④
The stiffness of the chest can be adjusted as required by loosening the thumb screw on
the back of the manikin: For reduced stiffness set to 'LOW' position, for increased stiffness
set to 'HIGH' position.
8
492 2840 40 vers 1_0_0_text.indd 8
LED Description
System running

System booting

System running and

low battery
System off

Flashing pattern
0 1 2 3 4 5 6 7
0 1 2 3 4 5 6 7 0 1 2 3 4 5 6 7
Seconds
0 1 2 3 4 5 6 7
Seconds Seconds
Seconds
0 1 2 3 4 5 6 7
0 1 2 3 4 5 6 7 0 1 2 3 4 5 6 7 Seconds
0 1 2 3 4 5 6 7
Seconds Seconds
Seconds
0 1 2 3 4 5 6 7
0 1 2 3 4 5 6 7 0 1 2 3 4 5 6 7
Seconds
0 1 2 3 4 5 6 7
Seconds Seconds
Seconds
0 1 2 3 4 5 6 7
0 1 2 3 4 5 6 7 0 1 2 3 4 5 6 7 Seconds
0 1 2 3 4 5 6 7
Seconds Seconds
Seconds
8/18/2009 1:30:13 PM