Arregui KURO Mode D'emploi page 9

8. OTHER CONTROL ELEMENTS
SCREEN CONTROL: To configure the screen so it does not
display the digits that are entered, press the
then the 3 button. If you would like the screen to display what
you enter, press the 3 button again.
SOUND CONTROL: To use the safe in silent mode, press the
button and then the 6 button. If you would like the safe to
emit sounds again, press the
BATTERY STATUS CONTROL: If you would like to know
whether the batteries are sufficiently charged, press the
button while the safe is closed. If the batteries are fine, the
screen will display HI-BAT, and if they are not, the message
will be LO-BAT. In that case, you should replace the batteries
with new ones.
In any case, if the batteries are not sufficiently charged, the
system will warn you of this when the safe is opened and
closed by displaying the OPEN LO-BAT or CLOSE LO-BAT
messages on the screen, respectively.
NOTE: During the battery change process, the safe will not
forget the codes that have been entered.
9. MAINTENANCE
Check the condition of the battery compartment on a regular
basis (every 6 months) to identify any possible signs of rust,
sulphation, etc.
Grease/oil any mechanical moving parts, such as locks and
bolts.
IMPORTANT
Recycling WEEE (waste electrical and electronic equipment)
is key as a safety measure in ensuring the health of people
and the environment. Always use specific collection centres
established for returning and managing used electrical
and electronic equipment. Before disposing of WEEE at a
collection centre, remove the batteries and dispose of them
separately so they may be managed correctly.
button and
6 button again.
GUARANTEE CERTIFICATE
This product is guaranteed for the periods stipulated in
the Law on Guarantees. ARREGUI is liable for any non-
conformities that may occur as a result of a manufacturing
fault that affects the performance of the product within the
legally prescribed timeframe. After this period, the consumer
will have to prove that the non-conformity already existed at
the time of receiving the product.
The warranty does not cover faults caused as a result of
improper use or installation, excessive moisture or salinity,
water or cement leakage, force, unauthorised manipulation of
the mechanisms, catastrophic events, knocks or falls.
The repair or replacement of any faulty part will involve an
extension of the guarantee of the repaired or replacement part,
in accordance with the provisions of the Law on Guarantees.
The purchaser must keep the RECEIPT for the purchase of the
product to be able to accredit the date of purchase.
En