Arregui KURO Mode D'emploi page 8

IMPORTANT:
The first opening of the safe
you must use the emergency
key:
• Insert the emergency key
with the red point and turn
it clockwise.
NOTE: Do not store the emergency key inside the safe
ATTENTION
Safes, whether they are desktop or wall safes, should be
installed such that the door is vertical and opens to the right,
except for specific models whose door opens to the left.
1. BATTERY INSTALLATION
Open the door, remove the plastic cover located behind the door
and place 4 new 1,5V AA batteries.
2. PROGRAMMING THE OPENING CODES
This safe allows to program two secret opening codes--one
standard and one master, from 3 to 6 digits each.
The initial standard code is 000000 and the initial master code
is 888888. For your security, it´s important that you change
them and configure the codes you desire.
During the process, use the
entered.
Programming the standard code (the safe must be open):
A. Press 00 and the
SELECT.
B. Press the 0 button (do not press
display SET.
C. Enter your code (3 to 6 digits) and press the
The screen will display DONE.
With the door open, verify that the new code operates correctly
(see section 3, opening the safe).
Programming the master code (the safe may be open or
closed):
A. Press 00 and the
SELECT.
B. Press the 1 button (do not press
display OLD.
C. Enter the current master code (888888 the first time)
and press the
(if the code entered is incorrect, it will display ERROR).
D. Enter the new master code (3 to 6 digits) and press the
button. The screen will display REPEAT.
E. Enter the new master code again and press the
button. The screen will display DONE (if the code entered
is not the same both times, the screen will display
ERROR).
- - -
+ + +
LOCK
button to delete the last digit
button. The screen will display
). The screen will
button. The screen will display
). The screen will
button. The screen will display SET
3. USER CODE RESET
Press the internal reset button with a not sharp object, the
screen will show "RESET1", the user code will return to the
initial 000000.
4. OPENING THE SAFE
Enter either of the two active opening codes and press the
button, then turn the key in clockwise direction to open the
door within 5 seconds.
If an incorrect code is entered, the screen will display ERROR1,
for a second incorrect attempt it will display ERROR2, and for a
third incorrect attempt it will display ERROR3 and the system
will remain blocked for 5 minutes, indicating by blinking HOLD
5... HOLD 4... etc. During this time, the keypad cannot be used.
5. CLOSING THE SAFE
Just turn the key in anticlockwise direction to close the door.
6. OPENING WITH THE EMERGENCY KEY
button.
If you do not have the opening codes, or if the batteries have
run out and an external battery is not available, you can open
the safe using the emergency key.
For this, access the emergency lock. Introduce the emergency
key provided with these instructions and turn it. The safe will
open.
Note: In case of an emergency opening due to a wrong code,
the emergency key opens the door but does not unblock the
electronic system, you must wait for the deadbolt time to expire.
7. OPENING WITH AN EXTERNAL BATTERY
If the batteries have run out, you can use the safe by placing
a 9V battery in the power supply located to the right of the
keypad.
Once the safe is open, replace the batteries.
Reset button
En