Stiebel Eltron EIL 3 Plus Utilisation Et Installation page 8

OPEraTION | INSTaLLaTION
Troubleshooting
6. Troubleshooting
Problem Cause
The appliance will not No power at the appli-
start despite the DHW ance.
valve being fully open.
The aerator in the tap is
scaled up or dirty.
The water supply has
been interrupted.
If you cannot remedy the fault, notify your qualified contractor.
To facilitate and speed up your request, provide the number from
the type plate (000000-0000-00000).
EIL . . . Nr.: 000000-0000-000000
8 | EIL Plus
INSTaLLaTION
remedy
Check the fuse/MCB in
your fuse box/distribu-
7.
tion board.
Clean and/or descale the
Only a qualified contractor should carry out installation, commis-
aerator or replace the
special aerator.
sioning, maintenance and repair of the appliance.
Vent the appliance and
the cold water inlet line
7.1
(see chapter "Settings").
We guarantee trouble-free function and operational reliability only
if original accessories and spare parts intended for the appliance
are used.
Safety
General safety instructions
Material losses
!
Observe the max. permissible inlet temperature. Higher
temperatures may damage the appliance. You can limit
the inlet temperature by installing a central thermostatic
valve.
www.stiebel-eltron.com