Stiebel Eltron EIL 3 Plus Utilisation Et Installation page 11

INSTaLLaTION
Installation
Undersink installation, non-pressurised, with non-pressurised
tap
10.2.1 Appliance installation
Note
The wall must have sufficient load bearing capacity.
f Mount the appliance on the wall.
www.stiebel-eltron.com

f Undo the cover fixing screws by two turns.
f Undo the snap fastener using a screwdriver.
f Remove the appliance cover with the heater towards the
front.
f Using pliers, break out the knock-out for the power cable
in the appliance cover. Correct the contours with a file if
necessary.


EIL Plus | 11