Trimmer Safety Warnings - Ryobi RBC42FSBO Manuel D'utilisation

■ Always stop the engine, allow it to cool, and make sure
all moving parts have come to a complete stop before:
● servicing
● leaving the product unattended
● cleaning your product
● changing accessories
● clearing blockages
● checking for any damage after hitting an object
● checking for any damage if the product starts to
vibrate abnormally
● performing maintenance
● removing the blade
● installing the blade
WARNING
Never use cutting means or attachments which are not
specifi ed by Ryobi in this manual. This includes the use
of metal multi-piece pivoting chains and fl ail-blades.
These items are known to break up during use and
present a high risk of serious injury to the operator or
bystanders.
WARNING
Inspection after dropping or other impacts: Thoroughly
inspect the product and identify any problems or
damage to it. Any part that is damaged should be
properly repaired or replaced by an authorised service
centre.

TRIMMER SAFETY WARNINGS

■ Replace string head if cracked, chipped, or damaged
in any way. Be sure the string head or blade is properly
installed and securely fastened. Failure to do so can
cause serious injury.
■ Avoid using on wet grass.
■ Do not walk backwards when using the product.
■ Walk, never run.
■ The small blade fitted to the cutting attachment guard
is designed to trim the new extended line to the correct
length, for a safe and optimum performance. It is very
sharp; do not touch it, particularly when cleaning the
product.
■ Always ensure that ventilation openings are kept clear
of debris.
■ Before each use and after any impact, check that there
are no damaged parts. Examine the cutting means
for signs of cracking or other damage. A defective
English (Original instructions)
■ Make sure the head attachment is properly installed
■ Make sure all guards, deflectors, and handles are
■ Do not modify the product in any way, this may
■ Use only the manufacturer's replacement line in the
■ Never operate the product without the cutting
■ Maintain a firm grip on both handles while trimming.
BRUSHCUTTER SAFETY WARNINGS
■ In addition to the above rules, these additional
■ Use heavy-duty gloves while installing or removing
■ Do not attempt to touch or stop the blade when it is
■ A moving blade can cause severe injury. Maintain
■ Replace any blade that has been damaged. Always
■ Use only the manufacturer's replacement Tri-Arc™ or
■ Never cut any material over 13 mm diameter for Tri-
■ Your brushcutter is fitted with a harness. Carefully
■ Identify the quick-release mechanism and practice
■ Cover the blade with the blade protector before storing
17
switch or any part that is damaged should be properly
repaired or replace by an authorised service facility.
and securely fastened.
properly and securely attached.
increase the risk of injury to yourself or others.
cutting head. Do not use any other cutting attachment.
attachment guard in place and in good condition.
Keep the string head below waist level. Never cut with
the string head located over 76 cm above the ground.
instructions are appropriate when using the product in
brushcutter mode.
blades. They have sharp edges.
rotating.
proper control of the product with both hands until the
blade has completely stopped rotating.
make sure the blade is installed correctly and securely
fastened before each use.
saw blade. Do not use any other cutting attachment.
Arc™ blade and over 40 mm diameter for the saw
blade.
adjust the harness to fit comfortably. The harness
supports the weight of the product at your right side.
using it before you start using the product. Its correct
use may prevent serious injury in the case of an
emergency. Never wear additional clothing over the
harness or otherwise restrict access to the quick-
release mechanism.
the product or during transportation. Always remove
the blade protector before using the product. If not
removed, the blade protector could become a thrown
object when the blade begins to turn.